Hi all,
I have STA broadcom driver installed.However I want to use the b43 for monitor mode for my AP.In Hardware drivers,only STA is left although initially even b43 was there,I tried to install b43 but always an error about installarchive() and to check var/log/jockey..i couldnt find this file for some reason.I have the fwcutter version(it says latest when I try to reinstall).
Also i have tried to check for blacklist.conf...
>>
# replaced by b43 and ssb.
blacklist bcm43xx" <<
is the line in file.
Also here is the content of the blacklist file blacklist-bcm43.conf
>>
# Warning: This file is autogenerated by bcmwl. All changes to this file will be lost.
blacklist b43
blacklist b43legacy
blacklist ssb
blacklist bcm43xx
<<
I unblacklisted the b43 and blacklisted wl,disabled the sta driver from system>hardware drivers and restarted.Had no internet so I had to activated it again.
Using file explorer to navigate to modprobe.d the blacklist and broadcom- wl- blacklist conf files are different from when using gedit through terminal! eg the warning in the bcmwl is not there using the file explorer to navigate!am getting much confused
Anybody have a clue on this,i would much appreciate.
ubuntu 10.0.4
2.6.32-24-generic